Witam

Mam problem w czujnikiem ciśnienia w przednim lewym kole ... po wymianie czujnika na nowy inny nowy prawy przestał działać wiec na dzień dzisiejszy nie pokazuje mi przodu. Przy włączonym zapłonie tyre pressure light miga pare razy po czym zapala sie na stałe. Czy poniższa procedura w czymś pomoże ?? Oczywiście mieszkając w Anglii brak tutaj ludzi specjalistów są tylko "mechanicy" wymieniacze ... :?

Próbowaliśmy komputerem adpotowac wymieniony czyjnik ale nie pomogło

poniższy schemat czy ma próbować w ten sposób ktomuś się udało ??

ok, you need to follow:
Step 1: Set the tires to the following pressures, they have to be exact:
Tire position Tire pressure kPa (kg/cm2, psi)
Front LH 240 (2.4, 34)
Front RH 220 (2.2, 31)
Rear RH 200 (2.0, 29)
Rear LH 180 (1.8, 26)

Step 2: Locate the TPMS interface plug. This is a white female plug that is attached to the OBD II wire loom under the dash right about where your left
knee would be when sitting in the driver's seat. You may have to cut the tape that is holding the TPMS interface plug to the OBD II wire loom.
Step 3: Attach a paper clip or wire into the interface plug.
Step 4: Put your key in the ignition and turn it to the last click before the engine starts. This is the KOEO position (Key On, Engine Off).
Step 5: Tap the end of the paper clip (the end NOT in the interface plug, duh!) on any exposed ground (metal) 6 times.
Step 6: If you completed step 5 then the TPMS warning light will start to slowly flash and you have activated the TPMS relearn process. If it flashes
fast that's not right. If yours isn't flashing slowly then check your connections, turn the ignition off and start over at step 4.

Dziękuję za pomoc

Michał