witam, jak w temacie, może ktoś wie jak zdjąć blokadę na DVD aby oglądać filmy podczas jazdy?
FX30dS
pozdr. Krzysztof
DVD podczas jazdy
witam, jak w temacie, może ktoś wie jak zdjąć blokadę na DVD aby oglądać filmy podczas jazdy?
FX30dS
pozdr. Krzysztof
Trochę roboty jest ale voila:
Z PARTNERSKIEGO FORUM INFINITISCENE.COM
http://www.infinitiscene.com/forum/t...-while-driving
This DIY is confirmed to work for 09 FX without Navigation. It allows for the Aux input to work while the vehicle is moving. (DO THIS AT YOUR OWN RISK)
Basically, this is how the Aux input works. Emergency Brake must be on (e-brake wire for the Audio Visual Controller must be grounded) and the vehicle cannot be moving (AV unit cannot detect a speed sensor signal). So, basically for this to work, you need to tell the AV unit the e-brake is on by grounding the e-brake wire and make sure the speed sensor signal never makes it to the control unit.
Grab the silver ring directly below the shift knob and pull it down. It will expose a metal clip. Pull the open ends to the side and take it out. Take the knob off by pushing the button and pulling it up.
Click here to view the original image of 768x1024px.
Open the lower center console storage bin, using your fingers pull the plate forward.
Click here to view the original image of 768x1024px.
Click here to view the original image of 768x1024px.
Lift the plate out.
Click here to view the original image of 768x1024px.
This next part is a little bit hairy. This part requires the most care. There are six clips that hold the center console trim. One at each corner and two at the center. Lift up at the back end first. When these two are up, slowly use one finger and slide it along the edge between the chrome strip and the piece. Once the driver side’s middle clip is lose, do the same on the other side. DO NOT just lift from the end hoping it’ll unclip the other four clips. Once both middle clips are lose, slowly slide your finger along the opening until the front two clips are off. Lift the trim and disconnect the connector.
Click here to view the original image of 1024x768px.
Click here to view the original image of 768x1024px.
Click here to view the original image of 768x1024px.
Click here to view the original image of 768x1024px.
Click here to view the original image of 768x1024px.
The ash tray has four clips. Pull from the bottom until the two lower clips are off. Get a small flat screw driver (be careful not to scratch the ash tray or console) and insert it into where the chips are. Push the screw driver toward the doors in order to pop the ash tray out. Once it’s out, disconnect the connector.
Click here to view the original image of 768x1024px.
Click here to view the original image of 768x1024px.
Click here to view the original image of 768x1024px.
Remove the two screws holding the AC control/radio panel.
Click here to view the original image of 768x1024px.
Click here to view the original image of 768x1024px.
Remove the two screws holding the upper radio panel/AC vent. This is one piece. So slowly lift from the bottom and unclip the three clips on the top.
Click here to view the original image of 768x1024px.
Click here to view the original image of 768x1024px.
Click here to view the original image of 768x1024px.
Click here to view the original image of 768x1024px.
Click here to view the original image of 768x1024px.
You should now see this.
Click here to view the original image of 768x1024px.
Unclip the harness that attaches to the upper trim.
Click here to view the original image of 768x1024px.
Unclip the three connectors that connect to the AC/lower radio panel.
Click here to view the original image of 768x1024px.
Click here to view the original image of 768x1024px.
The AV control unit is the one with the disc slot. It is held in by four screws. Two in the bottom and two at top.
Click here to view the original image of 768x1024px.
Click here to view the original image of 768x1024px.
Click here to view the original image of 768x1024px.
Pull the AV control unit, the wire harness we want to work with is the one on the left of the clip with three black antennae wires.
Click here to view the original image of 768x1024px.
The top row left most two wires are what we will be working with. Wire 107-RED is the Vehicle Speed Sensor wire. Wire 106-VIOLET is the Parking Brake Ground wire. Cut the RED wire and tape them up on both sides so the wire is not exposed. All we want to do is make sure the signal does not reach the AV unit. Next, cut the VIOLET wire and take the side coming out of the connector and connect it to a ground. (One of the four mounting screws is good)
Click here to view the original image of 1024x768px.
Click here to view the original image of 768x1024px.
Now put everything back in reverse order. Make sure you connect everything. Take your time or you will forget a connector. Once you’re done, you should be able to use the AUX input while the vehicle is moving.
Click here to view the original image of 1024x768px.
I'll do an update once I have a chance to look at the wiring diagram for the Nav equipped FX.
Richard
pozdrawiam
-Grzegorz-
__________________________________________________ _____________________________
SOLD :
'06 Brillant Silver/Black | Tech | Sport | Touring | HF package |Sponsors: STILLEN: STB | COLD AIR INTAKE |Z-TUBE | MOTORDYNE: 5/16 ISO |PLENUM SPACER|GIANELLE: 20" Spidreos
Teraz: Honda Accord Tourer '08 2.0 LPGCobalt Blue oraz Volvo V70 '02 D5 165 KM .
Proszę kolegów z zadawanie pytań na forum publicznym a nie na PW.
Problem, który znajdzie sie na forum szybciej doczeka się odpowiedzi i jednocześnie posłuży innym forumowiczom.
KeliV (10th-January-2013)
Wielkie dzięki ale sam sobie chyba z tym nie poradzę, może Ktoś już robił coś takiego i może polecić jakiś warsztat lub może sam coś
takiego wykonać w Wawie lub okolicach?
dasz rade)
przeciac 1 kabelek i 2 zmasowac.
pozdrawiam
-Grzegorz-
__________________________________________________ _____________________________
SOLD :
Teraz: Honda Accord Tourer '08 2.0 LPG
Problem, który znajdzie sie na forum szybciej doczeka się odpowiedzi i jednocześnie posłuży innym forumowiczom.
Wielkie dzięki, chyba zlecę to mojemu kumplowi, który ma zakład mechaniki pojazdowej, nie powinien mieć z tym problemu.Napisa? sirtrojan
Tylko tak się zastanawiam bo auto jest jeszcze na gwarancji czy nie będzie problemu z gwarancją jak zrobię coś takiego?
szczerze to może byc problem :/
pozdrawiam
-Grzegorz-
__________________________________________________ _____________________________
SOLD :
Teraz: Honda Accord Tourer '08 2.0 LPG
Problem, który znajdzie sie na forum szybciej doczeka się odpowiedzi i jednocześnie posłuży innym forumowiczom.
szkoda ze zmojego dvd w podsufitce nie ma dzwieku z glosnikow tylko musza byc sluchawki
...u mnie jest dźwięk więc można to jakoś ogarnąć...
Ostatnio edytowane przez Tomek g35c ; 20th-January-2013 o 18:08
***SOLD***2004 G35c: WhiteMatWrapped; GreenLedsInsite ;DBA+Hawk; 17"EOMBlackPainted;Bodykit-front bumper , Plenum Spacer, CAI - K&N; CatBack - Stillen Replica 2x2,5'' ; CatOut; OSIRIS Re-map*** ***SOLD: 2003 FX35: DBA+RedStuff; 20"EOMGoldPainted***
***2009 FX37S Premium, WhiteLedsInsite: EOM *** t.b.c.***`11 BMW 520d - gnojowóz
Wydaje mi sie ze mam nieorginalne dvd poniewaz zauwazylem ze dvd powinno byc w podlokietniku a u mnie jest w podsufitce.Brakuje pilota a moze tam bylo przelaczenie na glosniki,dodam ze dvd firmy audiovox
Koledzy podbijam temat bo minęło trochę czasu i może ktoś już ogarnia odkodowanie DVD/MPEG z pendrive podczas jazdy?
Uprawnienia
Odpowied? z cytatem
